Gibaud 0°/20° Standard Ventilated Knee Brace - Multiple Sizes

Gibaud 0°/20° Standard Ventilated Knee Brace - Multiple Sizes

Description and use
The 0°/20° Standard Ventilated Knee Brace helps immobilize your knee and restrict the movement of your knee joints.

• Pre-positioning strap.
• 4 semicircular straps.
• Pictos on the straps to indicate the tightening order.
• Removable side stays 0° or 20° flexion.

LPPR code: 7144972
LPPR: €57.23

For conditions that may benefit from knee immobilization, including the following:
• Traumatic injuries to the knee.
• Emergency immobilization.
• Pre/post-operative immobilization of the knee.

Precautions for use:
• The splint should not be used in cases where the pathology requires absolute immobilization or surgical intervention.
• Do not wear for prolonged periods without medical supervision.
• The splint should not be placed in direct contact with damaged skin.
• This splint is a single-patient use device. Do not reuse on multiple patients.
• When adjusting the straps, tighten to obtain a firm but comfortable fit.
• If any problems arise while using this splint, for example if pain or local signs appear, remove the device and contact your healthcare professional.
• If any serious incident occurs, related to the device, the healthcare professional and/or the patient must report it to the manufacturer and to the competent authority in the country concerned.

Set up :
A fitting is mandatory for a proper fit and a good understanding of the installation. The initial fitting will be carried out by a healthcare professional and subsequently by the user or someone close to them according to the same protocol.

The device can be worn over or under pants.

1. Opening the splint: Unfasten the straps, including the pre-positioning strap inside the device, and fold the hook-and-loop part over the straps.
2. Adaptation of the stays: The product is supplied with 0° lateral and dorsal stays. Two lateral stays with 20° flexion are provided with the device and, following the prescription of the healthcare professional, can be used in place of the 0° lateral stays. If necessary, refer to the illustrative drawings for the replacement of the 0° lateral stays with the 20° ones. During the fitting, the applicator will have to conform the dorsal stays of the orthosis to 20° to adapt it to your morphology.
3. Attaching the straps: Attach the pre-positioning strap slightly above the kneecap. Tighten to obtain a firm but comfortable fit. Attach and tighten without compressing the two straps closest to the kneecap (upper then lower) then the two straps further from the kneecap (lower then upper). Tighten the straps to obtain a firm but comfortable fit.

Maintenance and conservation:
• Keep the orthosis away from excessive heat sources.
• Hand wash in warm soapy water (maximum 40°C); rinse thoroughly; wring gently; do not bleach; dry flat, do not tumble dry; do not iron; do not dry clean.
• Dispose of the device and its packaging in accordance with local or national environmental regulations.