Back Belt 26 cm Lombogib® BB - One Size - Gibaud

Back Belt 26 cm Lombogib® BB - One Size - Gibaud

Description and use
The Lombogib® BB belt supports and reduces lower back pain associated with pregnancy.

• Supports and reduces lower back pain related to pregnancy.
• Specific straps to combat pelvic anteversion (hyperlordosis).
• 2 bands, with elastic comfort gusset, adaptable to the evolution of the pregnancy, support the belly without compressing it.

One size: Waist size: 80-140 cm

For lumbar conditions that may benefit from sacroiliac and suprapubic support, including:
• Lower back pain related to pregnancy.

Precautions for use:
• The orthosis must not be placed in direct contact with damaged skin.
• The device should not compress the abdomen and should not be worn for prolonged periods without medical supervision.
• This orthosis is a device for single-patient use. Do not reuse on multiple patients.
• If any problem occurs while using this device, remove it and contact your doctor.
• If any serious incident occurs, related to the device, the healthcare professional and/or the patient must report it to the manufacturer and to the competent authority in the country concerned.

Set up :
A fitting is mandatory for adaptation and a good understanding of the fitting. The first fitting will be carried out by a healthcare professional and later by a person close to the patient according to the same protocol.

During the fitting, the applicator must:

• (2A) Measure the waist circumference 2 cm above the iliac crests in order to choose the appropriate abdominal support.
• (2B) Conform the dorsal boning of the belt to adapt it to the patient's morphology.
• (2C) Adjust the height of the lumbar cushion by positioning it symmetrically to the spine, to adapt it to the patient's arch. Remove the maintenance protections from the belt.
• (2D) Hook one end of the belt onto one end of the abdominal support chosen in (2A) covering the entire round pad of the system
• (2E) Position the belt so that the stays are in a V shape on either side of the spine.
• (2F) Hook the second end of the abdominal support to the belt to close it.
• (2G) Adjust the abdominal support symmetrically, to obtain a tight fit without compression, by centering the elastic part under the abdomen.
• (2H) Adjust the elastic straps symmetrically to obtain optimized support, without compression.

Maintenance and conservation:
Preparation for washing:
• To preserve the appearance and performance of the belt, ensure that each hook-and-loop part is protected:
• (3A) Detach the abdominal support from the belt.
• (3B) Replace the elastic straps on the outer pads of the belt.
• (3C) Replace the maintenance protections on the internal belt attachment pads.
• (3D) Replace the pad on the inside of the belt.

Washing:
Hand wash in warm soapy water (maximum 30°C) or machine wash (delicate cycle 30°C); rinse thoroughly; spin gently; do not bleach; dry flat, do not tumble dry; do not iron; do not dry clean.
Keep the device away from excessive heat sources (radiator, tumble dryer, etc.).
Dispose of the device and its packaging in accordance with local or national environmental regulations.